OpenDCL e Bricscad V12

Started by Emiliano · 2012-02-16 13:13 UTC · 4 replies · SMF topic #1755

Emiliano 2012-02-16 13:13 UTC

I made an application with OpenDCL and AutoCAD2012.
It all works very well.
Now I would like to make the porting to Bricscad V12.1.15

I'm using: Runtime OpenDCL [7.0.0.2]

Unfortunately, Bricscad displays the following error message: The OpenDCL Runtime module failed to load. Please repair the installation OpenDCL and try again.

Can you help me understand why?
Thanks in advance

DanW 2012-02-16 14:46 UTC

Did you try reinstalling the 7.0.0.2 runtime module like the message suggested?

Is it possible the Bricscad was installed after the ODCL and therefore the original ODCL was not registered on the Bricscad?

Just a couple of thoughts.

Emiliano 2012-02-17 07:00 UTC

author=Danner link=topic=1755.msg8619#msg8619 date=1329403586 wrote:
Did you try reinstalling like the message suggested?

Is it possible the Bricscad was installed after the ODCL and therefore the original ODCL was not registered on the Bricscad?

Just a couple of thoughts.

Thank you!
reinstalling the 7.0.0.2 runtime module now works well in Bricscad V12. :D

DanW 2012-02-17 11:28 UTC

My pleasure Emiliano.

Its good to know everything is working well.

Dan

alcakelly 2012-05-18 06:35 UTC

Yup, after re-installation, ODCL is working well...